黄白茨煤矿021205工作面下向钻孔瓦斯抽采效果

为了考察黄白茨煤矿021205工作面下向钻孔抽采效果,从钻孔施工工艺、封孔工艺以及钻孔长度等方面考虑,选取021203工作面里段施工的上向钻孔抽采瓦斯效果作为参考。本文通过测定、收集、整理、分析021205工作面和021203工作面的瓦斯抽采数据,并得出021205工作面下向钻孔比021203工作面上向钻孔瓦斯抽采浓度衰减快,且衰减幅度大,021203工作面上向钻孔抽采效果优于021205工作面下向钻孔,并得出下向和上向钻孔瓦斯抽采浓度、流量等数据随时间变化的规律。     

Low temperature heat capacity measurements of β-Si3N4 and γ-Si3N4: Determination of the equilibrium phase boundary between β-Si3N4 and γ-Si3N4

Isobaric heat capacities of β-Si₃N₄ and γ-Si₃N₄ were measured at temperatures between 1.8 and 309.9 K with a thermal relaxation method. The measured heat capacities of γ-Si₃N₄ are smaller than those of β-Si₃N₄ in this temperature range. Using these data, we determined the standard entropies of β-Si₃N₄ and γ-Si₃N₄ to be 62.30 J·mol⁻¹ K⁻¹ and 51.79 J·mol⁻¹ K⁻¹, respectively. The equilibrium phase boundary between β-Si₃N₄ and γ-Si₃N₄ was calculated using these values and thermodynamic parameters reported in previous studies. The obtained equilibrium phase transition pressure at 2000 K is 11.4 GPa. It is lower than the experimental pressures at which γ-Si₃N₄ was synthesized in previous studies. The calculated Clapeyron slope at this temperature is 0.6 MPa K⁻¹, which is consistent with those of theoretical studies.     

管路清理器在煤矿排水系统中的应用

该文介绍了国内管路清理现状,分析目前国内管路清理方法的优缺点,推出一种新型管路清理方法——管路清理器。该方法采用特制的清理器,具有易操作、无污染等特点,在煤矿排水系统应用中取得良好的效果。     

油浸变压器消防排水系统的计算与设计

油浸变压器的消防及排水系统关系着电厂安全,但目前其消防排水的设计多凭经验估算。本文提出一套较为完整的变压器消防排水系统的计算方法,有利于提高设计质量。     

Low‐order optimal regulation of parabolic PDEs with time‐dependent domain

Observer and optimal boundary control design for the objective of output tracking of a linear distributed parameter system given by a two‐dimensional (2‐D) parabolic partial differential equation with time‐varying domain is realized in this work. The transformation of boundary actuation to distributed control setting allows to represent the system's model in a standard evolutionary form. By exploring dynamical model evolution and generating data, a set of time‐varying empirical eigenfunctions that capture the dominant dynamics of the distributed system is found. This basis is used in Galerkin's method to accurately represent the distributed system as a finite‐dimensional plant in terms of a linear time‐varying system. This reduced‐order model enables synthesis of a linear optimal output tracking controller, as well as design of a state observer. Finally, numerical results are prepared for the optimal output tracking of a 2‐D model of the temperature distribution in Czochralski crystal growth process which has nontrivial geometry. © 2014 American Institute of Chemical Engineers AIChE J, 61: 494–502, 2015     

NNI-1型C_5/C_6烷烃异构化催化剂长周期运行分析及建议

中国石化海南炼油化工有限公司0.2 Mt/a C5/C6烷烃异构化装置以连续重整装置的拔头油为原料,使用NNI-1催化剂,采用一次通过流程,不设脱异戊烷塔和稳定塔,经设在连续重整装置内的脱丁烷塔稳定处理后作为汽油调合组分。该装置于2006年9月开工投产,截至2015年3月已连续运行3个周期。长周期运行分析结果表明:前两个周期中NNI-1催化剂具有较高的异构化活性及选择性,C5异构化率为60%左右,C6异构化率为80%左右,C6选择性为15%左右,产品辛烷值基本达到技术指标要求(RON≥78);而在第三周期运行中,催化剂积炭增加等原因导致其异构化活性及选择性降低,异构化产品辛烷值提升能力呈现逐步衰减的趋势,提高反应苛刻度已不能弥补催化剂活性下降造成的产品辛烷值降低。为保证装置长周期运行,建议择机停工对催化剂进行再生,或是直接换用与装置原料性质匹配的异构化催化剂。     

改良森吉米尔法退火炉中带钢的氧化研究

总结了带钢经过改良森吉米尔退火炉后的4种氧化状态,通过现场实际生产经验的总结和数据积累,分析了带钢产生表面氧化的关键因素,指出了实际操作中应该注意的事项,为以后的设计调试及生产提供了参考。     

Thermal Bending Analysis of Doubly Curved Composite Laminated Shell Panels with General Boundary Conditions and Laminations

Thermal bending analysis of doubly curved laminated shell panels with general boundary conditions and laminations is presented. The equations of equilibrium are derived in the form of two coupled sets of ordinary differential equations based on a general shell theory and solved through the state-space approach in a repeated manner. It is depicted that the results of the present method are in great agreement with analytical solutions. Cylindrical shell panels with general boundary conditions and laminations, where no analytical solution is available, are solved. It is found that the present method exhibits a high convergence rate as well as presenting accurate results in all cases.